America's Leading Manufacturer of Innovative Water-Based Wood Finishes
The problem areas on your table are probably caused by surface contamination from oils, waxes or cleaning products used over the years.
Contaminants from dusting sprays that contain silicone will also impact the appearance and adherence of a finish - silicone is almost impossible to remove. Oil soaps and wax can also cause adhesion failures. This may be why the finish is performing differently on the leaves vs the table top. Adhesion failure is often more obvious in the deepest patterns of grain because the contamination is driven deep into the grain.
Arm-R-Seal Oil-Based Topcoats are made with the highest-quality urethane resin, making them extremely durable and long-lasting. Formulated to be wiped on with a cloth or applied with a foam brush, this ambering finish penetrates to provide deep-down protection for that "natural" look.
An unusual combination of oils, urethanes, and wax, Seal-A-Cell Clear has served craftsman for decades as the best wipe-on clear coat to get that "natural" look on beautiful woods. The oils penetrate deep into the wood to highlight the figure of the wood, and the urethane ensures durability.
Today we'd like to share with you this gorgeous table that was built and finished by Marion Lovett for his own home. This project was quite the challenge considering the table weighs in at about 800-900 lbs! It is 8" around and made of old oak barn wood.
Oil-based topcoats are "oxidizing" products which means that the moment it is introduced to oxygen, a chemical reaction will cause the finish to begin to harden. As topcoat is used, the empty space in the can is filled with air, furthering the curing process.
Tips to ensure your Arm-R-Seal remains in great working condition:
Although Arm-R-Seal rarely needs thinning because of its low viscosity, it can be thinned with up to 10% mineral spirits - more than that may thin the solids content too much.
Thinned Arm-R-Seal will be diluted but can be stored without risk of separation.
Linseed oil stains take a LONG time to dry. When applied too soon, Arm-R-Seal will likely prevent the linseed oil-based stain from gassing out and drying completely due to solvent entrapment, causing a haze.
Yes! But you must follow ONE simple rule to ensure the best possible finish: the underlying finish must be absolutely dry.
Pre-Stain Wood Conditioner with an oil-based stain is designed for use before staining new, soft, and porous wood surfaces, such as aspen, cherry, birch, poplar, or pine.
Enduro Water-Based Conversion Varnish
Enduro Water-Based Tintable 2K White Poly
Enduro Water-Based Pro Series White Polyurethane
Enduro Water-Based Tintable 2K Clear Poly
Hard Wax Oil & Hardener
Gel Stains
Water-Based Wood Stain
Pro Image Flooring Topcoat
Jen Poly Brushes
Stir Stix
Ultraflex Softback Sanding Sponge
TDS: Arm-R-Seal Oil Based Topcoat - 2021-12
