Site Search Results

General Finishes offers a complete coatings system with a finish for every objective.

Haze (the technical term is blush) is caused by too many coats applied too quickly. A recoat time of 12 hours is not enough dry time when applying over an EXISTING finish. To remove the blush or haze, you can either wipe the area with a strong solvent, like xylene or lacquer thinner, or you can try sanding out the haze and then reapply the topcoat.

The term for a cloudy, milky appearance in the finish is Blush. There are three causes:

     1. The most common reason is an incompatible stain. For example, using a water-based topcoat over an oil-based based stain. When the top coat is applied, the oil in the stain seeps up through the finish and reacts with the acrylic causing a chemical blush.

Yes! But you must follow ONE simple rule to ensure the best possible finish: the underlying finish must be absolutely dry.

Yes - this is not a good place to take shortcuts. GF Gel Stain gets its deep rich hue from a large number of colorants. Seal the stain with a topcoat before applying glaze to prevent "color pull."

The glaze will also glide more easily over the surface after topcoat is applied, allowing you greater control of how much color you want to use. Be sure to wait 72 hours when applying water-based finishes over oil-based finishes.

Yes! But you must follow a few simple rules to be sure you achieve the best possible finish.

You can use any of our topcoats.