GENERAL FINISHES PRO SEALER is a self-crosslinking single component sealer for hardwood floors designed to be used with Pro Floor Stains, Pro Image, and Pro Shield. Apply over Pro Stain the same day and save time and labor.
Pro Sealer represents the most recent advancements in technologies for the floor industry and has many advantages over traditional floor sealers:
GENERAL FINISHES PRO SEALER is a self-crosslinking single component sealer for hardwood floors designed to be used with Pro Floor Stains, Pro Image, and Pro Shield.
IMPORTANT: Record moisture meter readings in several places before applying Pro Sealer. These readings will provide a benchmark at later stages to determine when the floor is dry enough to apply another coat.
OVER BARE WOOD:
Apply two coats of Pro Sealer followed by two coats of Pro Shield.
OVER GENERAL FINISHES PRO FLOOR STAINS:
Before applying, allow Pro Floor Stains to dry 2 to 3 hours @ 70Â° / 70% humidity or until the moisture readings return to the original numbers.
OVER OIL BASE STAINS:
Allow oil based stains to dry 72 hours or twice as long as the manufacture recommends. Always test for adhesion before proceeding.
APPLICATION: Apply with T-Bar and mohair cover at a rate of 400-500 sq. ft. per gallon. If applying a second coat within six hours, buffing is not required. If applying after six hours, buff with maroon pad and 220 strips. Vacuum off all dust.
APPLICATION TIPS: If conditions are dry and warm, decrease or restrict the amount of air flow. Also increase the application rate and block direct sunlight when possible by closing shades or blinds.
DRY TIMES: 2 to 4 hours under ideal conditions (70 degrees / 70% humidity). The best method for judging dryness accurately is to use moisture meter readings.
NOTE: Many closed grain woods such as maple, walnut, and cherry may only require one seal coat and two finish coats. Most open grain woods such as the oaks and ash will need two seal coats to increase the build of the finish and improve the final result.
CLEAN-UP: Soap and water.
ADDITIONAL COATS: 2 to 4 hours (Always check with a moisture meter)
SOLIDS CONTENT: 34%
EXTERIOR USE: Not for exterior use
COVERAGE: 500 to 600 sq.ft./gal.
PACKAGING: Gallon plastic (4 per case) and 5 Gallon plastic pails
STORAGE: Keep from freezing.
SHELF LIFE: 1 year in unopened container.
VOC: Less than 250 grams per liter.
ASTM D 2243