Site Search Results

"Cure time" is the amount of time needed for the finish on a piece to reach maximum hardness and be ready for normal use. This is different than "dry time." 

Water-based finishes cure faster than oil-based finishes, approximately 21 days vs 30 days under ideal conditions (70°F and 50% humidity).

There are four benefits to using sanding sealer as the first seal coat prior to topcoat

Dry time is the recommended length of time between coats of product, often called recoat time, and cure time is the length of time recommended before subjecting your finished project to daily use. The following factors can influence your dry time:

One of the causes of orange peel is the application of too much fluid and not enough atomization to break the product up into smaller droplets. It's similar to putting your finger over the end of a garden hose. Increase the atomization by using smaller fluid tips or a larger spray unit. See General Finishes comparison chart for generally recommended spray tips. Contact your spray equipment manufacturer's recommendations as well.

ROUGH, DRY SURFACE 
This is called dry spray. You may have sprayed too lightly.

Re-sand the finish with 320-grit sandpaper and apply a heavier coat. Keep your gun at 6-8" from the surface.