Enduro Water-Based Conversion Varnish
Enduro Water Based Stain Blocker Primer
Enduro Water-Based Tintable 2K White Poly
Enduro Water-Based Pro Series White Polyurethane
Hard Wax Oil & Hardener
Gel Stains
Water-Based Wood Stain
Pro Image Flooring Topcoat
Jen Poly Brushes
Stir Stix
Ultraflex Softback Sanding Sponge
Although some companies promote their products as "no prep," that is nonsense. If you skip this step the finish can fail. General Finishes's standard for a good finish is it must adhere well and stand the test of time.
- Prep Sanding
- The most critical part of finishing a piece of furniture happens before you open a can of stain or paint - it starts with the sanding. Prep sanding an existing finish further cleans the surface, removing built up dirt, grime and oil from hands.
- Prep sand an existing finish with a 220 sanding pad.
- Prep Cleaning
- Cleaning an existing finish removes dirt, grime and many common contaminants such as dusting sprays, cleaners and oil from hands. Be especially careful in areas where hands are likely to touch (near knobs on cabinets and the tops of bannisters, for example). Dirt, grime and oil prevent good adhesion causing the possibility of chipping, peeling and flaking - all signs of a failed finish.
- We prefer a 50/50 mix of denatured alcohol and water because it does not contain phosphates, is inexpensive, is readily available and does not require rinsing.
- You can also use ammonia as a cleaner when using oil based finishes. We do not recommend using ammonia with water-based finishes as it can cause the finish to blush (turn white).
- 50/50 water/bleach or 50/50 water/vinegar solutions can be used as well - be sure to rinse with a warm, wet cloth and let the project dry.
- In cases where the project has a lot of buildup, we recommend scrubbing with a detergent such as Spic and Span first, followed by a rinse, then by the 50/50 mix of water and alcohol. Let your piece dry thoroughly.
- You can use commercial furniture cleaners such as TSP but check the label for phosphates - they will leave a residue behind that requires rinsing.
- Be Cautious of Contaminants
- Contaminants from dusting sprays that contain silicone will also impact the appearance and adherence of a finish - silicone may be impossible to remove. Oil soaps and wax can also cause adhesion failures.
