changing sheen

If you want to change the sheen, you can re-coat with a different sheen over top. The second layer of top coat will replace the appearance of the first.

Sand lightly with a used 220 sanding PAD to knock down the original finish before re-coating. It may take two or 3 coats to get complete coverage.

Rub down the finish with 0000 steel wool and General Finishes Orange Oil to lower the sheen.

Liberon 0000 Steel Wool is a good choice for steel wool, as it does not shred as easily as the hardware store brands.

Never use steel wool with water-based finishes. The steel wool particles can become embedded into your project and rust.

You can rub down the finish with 0000 steel wool and General Finishes Orange Oil to lower the sheen.

Pro Tip: GF does not recommend using steel wool with water-based finishes because the particles can become embedded and rust.

Contributed by Jeff Jewitt of Homestead Finishing Supplies

Day 1:

• Prep sand the wood with 220-grit sandpaper.
• Spray a wet coat of General Finishes Enduro-Var Gloss and dry for 2 hours.
• Level sand with 320-grit sandpaper.
• Spray a second wet coat and dry for 2 hours.
• Lightly sand with 320-grit sandpaper.
• Spray a third wet coat and allow to dry overnight.

Day 2:

• Level sand with 320-grit sandpaper.
• Wipe down with water mixed with 5% Denatured Alcohol.
• Spray a fourth wet coat 2-3 mils thick and dry 1 hour.
• Spray 3 more coats, 1 hour between coats, for a total of 4 coats the second day.

Let your project dry 1 week, then:

• Level sand dry with Mirka P800.
• Dry sand with Mirka P1200.
• Dry sand with 2000-grit Mirka Abralon.

Note: Do not use any lubricants of any type for sanding.

Final:

• Buff 3M Finesse-It Material on with foam buffing pad to high gloss.