Site Search Results

Rubbing or Buffing out a Finish:

There are several techniques by Jeff Jewitt of Homestead Finishing Products:

DRY BUFF WITH MIRKA ROYAL MICRO PAPER

Using Mirka Royal Micro sandpaper, always start with 1500-grit sandpaper. Begin with a small area, make 2-3 passes, then evaluate results. Go to a heavier grit if surface irregularities are not fully removed. Finish with 1500-grit paper.

First, test your surface to get a sense for the color present in the wood. To do this, wipe the surface down with mineral spirits (if you are expecting to use an oil finish) or plain water (if you are expecting to use a water based finish). See the following GF video demonstration for a better understanding of this process.

Next, apply product. Here are two recipes for a lightly stained look:

No, General Finishes Milk Paint is premium paint developed for commercial applications and is durable enough to stand up to most wear without top coat.

If increased sheen or maximum durability for high-use areas (cabinets, table tops) is required, GF recommends applying 2-3 coats of GF's High Performance or Enduro professional topcoats.

Yes - this is not a good place to take shortcuts. GF Gel Stain gets its deep rich hue from a large number of colorants. Seal the stain with a topcoat before applying glaze to prevent "color pull."

The glaze will also glide more easily over the surface after topcoat is applied, allowing you greater control of how much color you want to use. Be sure to wait 72 hours when applying water-based finishes over oil-based finishes.

Yes! But you must follow ONE simple rule to ensure the best possible finish: the underlying finish must be absolutely dry.