Site Search Results

It is normal to see a bit of stain on the brush when applying the first coat of topcoat. Topcoats often pull a bit of color on the first pass, but good preparation will minimize this.

To prepare open grains woods such as raw Oak for a water-based stain, we recommend sanding with 180-grit followed by no more than 220-grit sandpaper.

There are several reasons to choose Dye Stain. Here are a few.

Yes, one of its uses is to dilute dye stain colors. Dye Stain reducer is the clear base the we use when manufacturing our dye stains. We make the reducer first, then add the dye color.

It is easy to make your own custom color Dye Stain by adding in 10% increments until you achieve the color you want. It is not possible to mix too much of our dye stain or reducer together.

Additionally, General Finishes Water Based Stains can be mixed into the reducer, which will lighten the color and thin the viscosity so it will penetrate deeper into the wood.

General Finishes Enduro line of water-based coatings is formulated for professional, industrial and OEM for operations. Comprehensive videos for each product are available on YouTube, and comparison charts at www.GeneralFinishes.com.

Yes, there are a couple of ways. Dye Stain Reducer is the clear base that we use when manufacturing General Finishes Dye Stains. The Reducer is made first, then the dye color is added.

It is easy to make your own custom color Dye Stain by adding in 10% increments of Dye Stain color to Reducer until you achieve the color you want. It is not possible to mix too much of our Dye Stain and Reducer together.