Site Search Results

General Finishes does not think light scratches on a door are so significant that it would be necessary for you to strip down the finish. 

Instead of stripping, GF recommends that you try:

Our recommendation to fix white cabinets that have yellowed is to do a thorough sanding and precleaning and recoat with the following products:

GF advises extra care and prep when applying any finish over laminate surfaces because they are specifically designed not to mar and therefore they are not very "sand-able", making adherence difficult.

In addition to this non-permeable surface factor, General Finishes Gel Stain is an oil-based product, and it is more difficult to obtain proper drying characteristics over a dense manufactured surface such as laminate. Gel stains, as all wood stains, were formulated to go over raw wood which has an "open" surface and can absorb some of the stain.

There are several reasons:

1. The cabinets were not prep cleaned and sanded properly. Sanding and cleaning are an essential part of any refinishing process.

In most cases, you can use a 220 sanding pad to scuff the surface and clean with a 50|50 mix of water and denatured alcohol.

This issue is caused by a change in humidity in the house when the winter heating season starts. This is a very typical problem when painting over existing finishes. The cracking is a result of expansion and contraction.

When you apply numerous heavy layers of primers, paints, and topcoats, they can crack at the joints or angles when the humidity changes. The cracking occurs when the door panel shrinks and breaks the heavy paint layer.

There are two options when it comes to fixing this problem: 

Vinyl or paper veneers can be often found on the end returns of lower price-point cabinets. We cannot guarantee that our paints will adhere well to a paper veneer - we have no idea what the actual material is or what adhesives were used to apply the veneer to the surface. The resins and additives in our paints may break down the adhesives used for the veneer.

And Milk Paint does NOT adhere to vinyl.

It is normal to see a bit of stain on the brush when applying the first coat of topcoat. Topcoats often pull a bit of color on the first pass, but good preparation will minimize this.

To prepare open grains woods such as raw Oak for a water-based stain, we recommend sanding with 180-grit followed by no more than 220-grit sandpaper.

The hardness properties of a wood finish are formulated around the objectives of use. A hard finish is desirable on projects that get heavy wear such as kitchen cabinets or table tops.

But in other situations, such as an outdoor topcoat, a desired property of the finish is elongation, which allows the topcoat to expand and contract through different extremes of temperature.