Site Search Results

Arm-R-Seal Oil-Based Topcoats are made with the highest-quality urethane resin, making them extremely durable and long-lasting. Formulated to be wiped on with a cloth or applied with a foam brush, this ambering finish penetrates to provide deep-down protection for that "natural" look.

Arm-R-Seal can be sprayed successfully, but we prefer hand application methods because it is very easy to spray too much in one area. If you choose to spray, use very thin coats and watch for runs (large drips that run down the side of your project).

If you notice a run, immediately wipe or brush it out. If you correct a run promptly, you will not see a mark. However, dried runs can be difficult to remove.

We all know that steam spots can come as the result of hosting holiday celebrations! But how does GF recommend dealing with the mark?

Arm-R-Seal Blotching

The problem areas on your table are probably caused by surface contamination from oils, waxes or cleaning products used over the years.

Contaminants from dusting sprays that contain silicone will also impact the appearance and adherence of a finish - silicone is almost impossible to remove. Oil soaps and wax can also cause adhesion failures. This may be why the finish is performing differently on the leaves vs the table top. Adhesion failure is often more obvious in the deepest patterns of grain because the contamination is driven deep into the grain. 

General Finishes Oil Based Arm-R-Seal Topcoat

Oil-based topcoats are "oxidizing" products which means that the moment it is introduced to oxygen, a chemical reaction will cause the finish to begin to harden. As topcoat is used, the empty space in the can is filled with air, furthering the curing process. 

Tips to ensure your Arm-R-Seal remains in great working condition:

General Finishes offers a complete line of oil based, water based and wax products. Application techniques differ between oil based products and water based products.

Our recommendation to fix white cabinets that have yellowed is to do a thorough sanding and precleaning and recoat with the following products:

ANSWER:

It depends! Read on, or watch this GF video demonstration: http://youtu.be/torOAQy91q4

*Here are the main questions to ask yourself:

You can apply Gel Stain to MDF, stained surfaces

Relevant Documents