Pro Image Topcoat - One Part Water Based Flooring Topcoat

Waterbased one part topcoat for floors

Pro Image Water Based Flooring Topcoat - durable, one part, and self-crosslinking urethane/acrylic water base top coat- the only high wear single component on the market.


  • Maintains clear finish and will not yellow over time
  • Low odor and low VOC
  • Superior scratch, scuff and heel mark resistance
  • Uses an internal hardener to give superior durability
  • No need to shake - simply stir and it's ready to use
  • Superior slip resistance over other one component coatings
  • Exceptional clarity
  • Fast dry times
  • Part of a fully non-combustible finishing system
  • Meets MFMA standards
  • COF - .58


Application Brochures

PRO IMAGE is a single component urethane for hardwood floors designed to be applied over Pro Floor Stains or Pro Sealer.

IMPORTANT: Record moisture meter readings in several places before applying stain or sealer on the raw floor. These readings will provide a benchmark at later stages to determine when the floor is dry enough to apply another coat.

Allow stains to dry 2 to 3 hours @ 70°/70% humidity or until the moisture meter readings return to their original numbers.

Allow Pro Sealer to dry for 2 to 3 hours or until the moisture meter readings return to their original numbers. Then buff with Maroon Pad and 240 grit sandpaper strips, a 3M Hi Pro Pad, or equivalent. Vacuum all dust from floor. Tack rag with water dampened towels.

Allow oil based stains to dry 24 to 48 hours or twice as long as the manufacture recommends. Always test for adhesion.

APPLICATION: Apply with T-Bar and mohair cover or roller at a rate of 500-600 sq.ft. per gallon. Two coats are recommended. If applying the second coat within six hours, buffing is not required. If applying after six hours, buff with maroon pad and 220 strips. Vacuum off all dust and apply second coat.

APPLICATION TIPS: If conditions are dry and warm, restrict the amount of air flow. Also increase the application rate and block direct sunlight by closing shades or blinds.

RE-COATING EXISTING FLOORS: Clean all wax, grease, and oils; then buff finish with maroon pad and 240 strips. Vacuum all dust and apply 1 or 2 coats of Pro Image.

SHEENS: Flat 10, Satin 35, Semi-Gloss 65, Gloss 85

DRY TIMES: 2 to 4 hours under ideal conditions (70°/70% humidity). The best method for judging dryness accurately is to use moisture meter readings.

COATS: 1 to 2

CURE TIME: Floor may be used socks only in six hours, furniture in three days, and rugs in ten days. Be careful during the first ten days as the finish is more susceptible to scratching and scuff marks.  Place heavy furniture on carpet pads.

CLEAN UP: Soap and water

ODOR: Mild


DEFOAMING: Excellent

LEVELING: Excellent

COVERAGE: 500 to 600 sq. ft./gal.

STORAGE: Keep from freezing.

SHELF LIFE: 1 year in unopened container

PACKAGING: Gallon plastic (4 per case) and 5 Gallon plastic pails

VOC: less 250 grams per liter

ASTM D 2243
WARNING: We do not test the compatibility of General Finishes products with all competitive brands, and are not liable for compatibility issues. It is your responsibility to test compatibility before using. This product contains a chemical known to the State of California to cause cancer and birth defects.


Material Safety Data Sheets
Technical Data Sheets